Samsung Tab 3 temperature issue

Hi,

As a hobby project for my daughter I wanted to build in an old Samsung tab 3 P5220 in her bureau. I intended to charge the tab 3 directly, without the already broken battery.
I cut the six battery wires, two black, two blue and two red. I soldered the two black wires to the black wire of a USB cable and did the same with the two red ones. Then I connected the two blue wires with a 10k ohm resistor to ground (black wires). After a successful boot the tab 3 was showing, within a couple of seconds, the message: Closing down the apps, as the device is overheating, which was not the case of course..
I tried using a 5 volt charger, wired to an USB cable (default) with the above result, but also tried to switched to 4.5 volt, (only the Samsung tab 3 words appeared, presumable because of a too low voltage the boot did not succeeded). I hooked up to another laptop's USB port, same overheating "error" message. I can use (according to a screen message) calls and use the contacts, but the rest is blocked. Is a hardware sensor responsible for this issue? I can't seem to find an solution in the software for this overheating problem either. My daughter like to use a my little pony app and is not so much interested in calling nor contacts..
Any help or suggestion would be greatly appreciated.

Show Accepted Answer

Guest Quick Reply (No URL, BBcode or HTML)

Last post by jeanie.reynolds
2 hours ago
Last post by moore.cooper
2 hours ago
Last post by vtoy
4 hours ago
Last post by moen.arnoldo
2 hours ago
Last post by bridie.kuhlman
42 minutes ago
Last post by mruecker
1 hour ago
sd card help
Started by bsanford
Last post by pattie51
4 hours ago
Last post by monserrat.towne
4 hours ago
Last post by benedict.koepp
2 hours ago
Last post by candice.gorczany
17 minutes ago
Last post by hamill.nina
3 hours ago
Last post by ziemann.maureen
3 hours ago